Effect of adhesive stiffness and thickness on stress distributions in structural finger joints

Abstract

Environmental, political, and socioeconomic actions over the past several years have resulted in a decreased wood supply at a time when there is an increased demand for forest products. This combination of increased demand and decreased supply has forced more emphasis on engineered wood products, a varied category usually connected with adhesively-bonded end joints, of which the most common type is the finger joint. This paper presents the results of a finite-element analysis of structural finger joints, and focuses primarily on the effect of adhesive stiffness and thickness on stress distribution patterns in finger joints. Results indicate that a flexible adhesive layer concentrates adherend longitudinal and radial stresses at the finger base, whereas a stiff adhesive layer minimized adherend stresses but increases adhesive stress levels. Results also show that a thin adhesive layer concentrates longitudinal adherend stresses at the juncture of the finger tip and flexible finger base and concentrates radial stresses at all finger bases. However, these increased longitudinal and radial stresses are balanced by reduced adhesive shear stresses.

Citation

Groom, Leslie H.; Leichti, Robert J. 1994. Effect of adhesive stiffness and thickness on stress distributions in structural finger joints. J. Adhesion 44:69-83