Treesearch
Displaying 26,501 - 26,510 of 65,215 Publications- The objective of this study was to investigate how a stress wave travels in a standing tree as it is introduced into the tree trunk through a mechanical impact. A series of stress wave time-of-flight (TOF) data were obtained from three freshly-cut red pine (Pinus resinosa Ait.) logs by means of a two-probe stress wave timer. Two-dimensional (2D) and three-dimensional (3D) stress wave contour maps were constructed based on the experimental data using a commercial software. These stress wave contour maps represent the wave fronts in a time sequence, illustrating the flow of stress wave...AuthorsHoujiang Zhang, Xiping Wang, Juan SuKeywordsWood deterioration, red pine, pine, grading, mechanical properties, wood grading, acoustic properties, wood quality, wood defects, stress waves, nondestructive testing, acoustic imaging, Pinus resinosa, wood testing, testing methods, pine decay, standing trees, acoustic testing, wood decay, log quality, log grading, 2D stress wave contour maps, 3D stress wave contour maps, knots, logs, stress wave contour map, stress wave propagation, time-of-flight, wave frontSourceHolzforschung. Vol. 65, no. 5 (Aug. 2011): p. 743-748.Year2011
Age versus size determination of radial variation in wood specific gravity : lessons from eccentrics
Radial increases in wood specific gravity have been shown to characterize early successional trees from tropical forests. Here, we develop and apply a novel method to test whether radial increases are determined by tree age or tree size. The method compares the slopes of specific gravity changes across a short radius and a long radius of trees with eccentric trunks. If radial changes are determined by size, then the slope of the change should be the same on both radii. If radial changes are determined by age, then the slope should be greater on the short radius. For 30 trees from 12...AuthorsG. Bruce Williamson, Michael C. WiemannKeywordsSourceTrees. Vol. 25, no. 4 (Aug. 2011): p. 585-591.Year2011- The objective of this paper is to determine the kiln conditions necessary to avoid interior enzymatic oxidative discoloration in soft maple. Three drying chambers were designed and constructed to control temperature and relative humidity of maple test samples. The tests showed that drying as soon as possible after harvest at temperatures below 42°C will greatly reduce drying discoloration in soft maple.AuthorsMichael C. Wiemann, Mark Knaebe, Scott A. BoweKeywordsSourceResearch paper FPL-RP-661. Madison, WI : U.S. Dept. of Agriculture, Forest Service, Forest Products Laboratory, 2011: 4 p.Year2011
- AuthorsAlex C. WiedenhoeftYear2011
- Five wooden sculptures from the pre-contact Caribbean, long held in museum collections, are here dated and given a context for the first time. The examples studied were made from dense Guaiacum wood, carved, polished and inlaid with shell fastened with resin. Dating the heartwood, sapwood and resins takes key examples of ‘Classic’ Ta´ýno art back to the tenth century AD, and suggests that some objects were treasured and refurbished over centuries. The authors discuss the symbolic properties of the wood and the long-lived biographies of some iconic sculptures.AuthorsJoanna Ostapkowicz, Alex C. Wiedenhoeft, Christopher Bronk Ramsey, Erika Ribechini, Samuel Wilson, Fiona Brock, Tom HighamKeywordsCaribbean, Taino, wood, sculpture, tenth–sixteenth centuries AD, ethnohistory, Caribbean art, carving, decorative arts, figure sculpture, wood sculpture, American sculpture, ancient sculpture, ethnology, Cuba, Ta´ýno sculpture, Ta´ýno art, Ta´ýno Indians, antiquity, Ta´ýno wood-carving, wood-carving, Hispaniola, Caribbean Americans, art, Guaiacum, prehistoric antiquities, Indians of the West Indies, wood identification, cultural property, cultural heritageSourceAntiquity. Vol. 85 (2011): p. 942-959.Year2011
- The need for accurate and rapid field identification of wood to combat illegal logging around the world is outpacing the ability to train personnel to perform this task. Despite increased interest in non-anatomical (DNA, spectroscopic, chemical) methods for wood identification, anatomical characteristics are the least labile data that can be extracted from solid wood products, independent of wood processing (sawing, drying, microbial attack). Wood identification using anatomical characteristics is thus still a viable approach to the wood identification problem, and automating the process...AuthorsJohn C. Hermanson, Alex C. WiedenhoeftKeywordsSourceIAWA journal. Vol. 32, no. 2 (2011): p. 233-250.Year2011
- The movement of firewood within emerald ash borer- (EAB-) infested states and into adjoining states has been a major contributor to the spread of EAB throughout the United States and Canada. In an effort to stop the further spread of EAB from infested areas and to facilitate interstate commerce, USDA Animal and Plant Health Inspection Service (APHIS) has required and are enforcing a heat-treatment process in the firewood industry to heat sterilize firewood before it can be shipped out of infested areas. States and firewood producers are now faced with challenges implementing heat-treatment...AuthorsXiping Wang, Richard Bergman, Brian K. Brashaw, Scott Myers, Marc JoyalKeywordsSourceGeneral technical report FPL-GTR-200. Madison, WI : U.S. Dept. of Agriculture, Forest Service, Forest Products Laboratory, 2011: 34 p.Year2011
- We investigated how multiple fuel treatment types, organized in varying spatial arrangements, and at increasing proportions of a mixed-conifer forest in the Klamath Mountains of northern California (~20,000 ha) variably affect carbon sequestration and emissions over a 50 year time period. Preliminary analysis of three fuel treatment scenarios (fire only, mechanical only, and fire + mechanical) and an untreated landscape indicates that treating large areas with prescribed fire may increase carbon emissions in the short term but may be off-set by an increase in long term carbon storage.AuthorsK. Osborne, C. Dicus, C. Isbell, Alan Ager, David R. Weise, M. LandramSourceIn Wade, D.D.; Robinson, M.L. (eds) Proceedings of the 3rd Fire Behavior and Fuel Conference, Oct. 25-29,2010, Spokane, Washington, USA. International Association of Wildland Fire, Birmingham, Alabama, USA. 5 pYear2011
- Airborne remote sensing at infrared wavelengths has the potential to quantify large-fire properties related to energy release or intensity, residence time, fuel-consumption rate, rate of spread, and soil heating. Remote sensing at a high temporal rate can track fire-line outbreaks and acceleration and spotting ahead of a fire front. Yet infrared imagers and imaging spectrometers typically used for earth remote sensing are saturated by—and incapable of measuring—the very bright infrared light that radiates from wildland fires. The Forest Service, Pacific Southwest Research Station, and its...AuthorsPhilip J. Riggan, Lynn G. Wolden, Bob G. Tissell, David R. Weise, J. CoenKeywordsSourceIn Wade, D.D.; Robinson, M.L. (eds) Proceedings of the 3rd Fire Behavior and Fuel Conference, Oct. 25-29,2010, Spokane, Washington, USA. International Association of Wildland Fire, Birmingham, Alabama, USA. 14 pYear2011
- Observed fire spread rates from 240 laboratory fires in horizontally-oriented single-species live fuel beds were compared to predictions from various implementations and modifications of the Rothermel rate of spread model and a physical fire spread model developed by Pagni and Koo. Packing ratio of the laboratory fuel beds was generally greater than that observed in natural stands of chaparral. Fuel bed moisture content was greater than that in Rothermel's or in Wilson's data. Correlation between observed and predicted spread rate was 0 for Rothermel's original model and ranged from 0.07...AuthorsDavid R. Weise, E. Koo, X. Zhou, S. MahalingamKeywordsSourceIn Wade, D.D.; Robinson, M.L. (eds) Proceedings of the 3rd Fire Behavior and Fuel Conference, Oct. 25-29,2010, Spokane, Washington, USA. International Association of Wildland Fire, Birmingham, Alabama, USA. 17 pYear2011